Pulling the sheet…
Pulling the sheet…
Workshop manual · Vol. 1 · 24 sheets
Calculators for the garage, the dyno cell and the pit wall. Drag a slider, watch the drawing move, read the number. Every sheet shows its working.

Sketch a dyno curve and read power from torque at any engine speed.

Bore, stroke and cylinder count to swept volume in cc, litres and cubic inches.

Static compression from chamber, gasket, deck and piston volumes.

Mean and peak piston speed, rod ratio and g-load at top dead centre.

Pick injector flow and fuel pump size for a target power level.

Pressure ratio, charge temperature and estimated power under boost.

Road speed in every gear, shift drops and cruising revs.

Final-drive ratio from tooth counts, and what bigger tires do to it.

Estimate ET and trap speed from weight and power, then run the strip.

Convert between flywheel and wheel horsepower with drivetrain loss.

Decode a tire code into diameter, sidewall, circumference and revs.

Compare two sizes: speedometer error, ride height and gearing change.

See how new width and ET move the wheel toward strut or fender.

How pressure rises as tires heat up, and what to set them to cold.

Reaction plus braking distance for any speed, surface and gradient.

Drag force, power demand and the speed where power runs out.

Lateral g for a corner radius and speed, against your grip limit.

Front/rear, left/right and cross-weight from four scale readings.

Wheel rate, natural frequency and the suspension frequency response.

Convert L/100 km and mpg, then price a journey.

Charge time, cost and range added, with a realistic taper curve.

Size 12 V wiring for current, run length and voltage drop.

Sealed enclosure Qtc, F3 and frequency response with cabin gain.

Power, torque, pressure, speed and more on a sliding scale.